Table of Contents
Advertisement
Recommended Weekly Operator Maintenance
CAUTION:
Never attempt any maintenance that is not speci ically described in this
documentation. Please contact your Dealer for authorized servicing.
Recommended Weekly Operator Maintenance
To maintain the accuracy and reliability of this machine it is recommended to carry out the
following maintenance on a weekly basis:
1. Power off the machine using the main power switch. Remove any remaining paper
from the feeder table.
2. Wipe down the feeder table and other paper path surfaces.
3. Check feeder separator pads for damage or wear.
4
4. Clean vacuum belts and paper feed rollers from any paper or toner dust using the sup-
plied roller cleaning brush [A].
5. Remove the rotary tool carrier to clean its rollers.
6. Remove and clean the Quick Release Blade creasing blade.
7. Clean all sensors using the supplied sensor cleaning brush [B] (see next page).
•
Table empty sensor Q11 [C]
•
Separated paper (SP) sensor Q12 [D]
•
Top down paper sensor Q4 [E]
•
Input sensor Q20 [F]
•
Creaser home sensor(s) [G]
•
Clean the suction belts [H] with rubber reactivator alcohol.
•
Check the separator pads [I] for wear, tear and position (refer to 'Seperation
Pad check' in section 3 of this manual for how to measure the default position).
Replace if worn (rounded edges/warped) or if broken.
A
90
NOTE:
For instructions on how to remove the
creasing blade, see the "Replacing
Quick Release Blade Sets" section
within this manual.
B
Continued on next page...
Advertisement
Table of Contents
