FE-101 - Misfeed
This code is displayed if the ultrasonic double sheet detector (US DSD) Q10 was not ac-
tivated in time after the start of the feed cycle. This means that the sheet has failed to exit
the feeder table area.
Actions:
•
Remove the jammed sheet (if any) from underneath the vacuum belts. If the
sheet is damaged, discard it.
•
Check the paper path for any obstructions or debris.
•
Check that the paper loaded in the feeder matches the parameters (size and
thickness) set in the UI.
•
Fan the paper stack to ensure sheets are not stuck together and there is no
excessive buildup of static electricity.
•
Check that feeder magnetic side guides do not stop the sheet from freely exiting
the feeder.
•
If frequent misfeeds keep occurring after carrying out the above actions:
•
Check that the sheet can freely pass between the separation pads and the
vacuum belts.
•
Turn off feeder AUTO settings and increase one or more of the following param-
eters: paper density, vacuum fan, separation fan.
NOTE:
See the "Feeder Settings" section of this manual for instructions on how to do this.
FE-102 - Double sheet
This code is displayed when the ultrasonic double sheet detector (US DSD) Q10
has detected two or more overlapping sheets exiting the feeder at the same time.
Actions:
•
Remove the jammed sheets from underneath the vacuum belts. If the sheets
are damaged, discard them.
•
Check the paper path for any obstructions or debris.
•
Check that the paper loaded in the feeder matches the parameters (size and
thickness) set in the UI.
•
Fan the paper stack to ensure sheets are not stuck together and there is no
excessive buildup of static electricity.
•
If frequent double feeds keep occurring after carrying out the above actions:
•
Turn off feeder AUTO settings and increase one or more of the following param-
eters: paper density, vacuum fan, separation fan.
•
If using laminated paper or other multi-layered stock, switch off the US DSD.
NOTE:
See the "Feeder Settings" section of this manual for instructions on how to do this.
Continued on next page...
3
75