Table of Contents
Advertisement
Creaser Calibration Check
To check that the machine has not lost its factory set crease calibration during shipping
and/or handling carry out the following procedure:
1. Turn off Fold, run a proof sheet with a half fold pattern.
2. Measure the distance between the lead edge of the paper and the crease. The meas-
urement should equal to the paper length divided by 2.
Feed direction
3. If the measurement is not within the machine tolerance (± 0.25 mm / ± 0.001") contact
contact a certified service technician.
Crease
Measure
3
83
Advertisement
Table of Contents
