Anvil strip removal / replacement
WARNING!
All blades are very sharp: use extreme caution. Leather gloves must be worn
whenever handling the blades.
NOTE:
Before replacing anvil strip decrease perforation depth to avoid causing excess strain
on motor and reducing lifespan of anvil strip. adjustment procedure can be found under
'perforation depth adjustment'.
1. Locate the Allen tools supplied with the Cross Perforation kit.
2. Place the cross perforation tool on a table in the orientation shown below.
3. Remove one guide bolt [C] and spring [D]. Only one side needs to be removed.
B
A
NOTE:
Each anvil strip can be used
twice. When perforation is no
longer effective the anvil strip
can be rotated 180 degrees to be
reused.
D
Continued on next page...
1
C
41