Table of Contents
Advertisement
FE-103 - Sheet too long
When a sheet exits the feeder the ultrasonic double sheet detector (US DSD) Q10 meas-
ures its length to ensure the sheet matches machine settings. Error code FE-103 is dis-
played if the sensor Q10 is covered longer than expected. This can be either because the
sheet is too long or because there is insufficient grip on the registration belts and the sheet
cannot be fed forward.
Actions:
•
Remove the jammed sheet from underneath the vacuum belts. If the sheet is
damaged, discard it.
3
•
Check the paper path for any obstructions or debris.
•
Check that all sheets in the stack are the same length.
•
Check that the paper loaded in the feeder matches the parameters (size and
thickness) set in the UI.
•
Fan the paper stack to ensure sheets are not stuck together and there is no
excessive buildup of static electricity.
•
Check that feeder magnetic side guides do not stop the sheet from freely exiting
the feeder.
FE-104 - Sheet too short
When a sheet exits the feeder the ultrasonic double sheet detector (US DSD) Q10 meas-
ures its length to ensure the sheet matches machine settings. Error code FE-104 is dis-
played if the sensor Q10 is covered for less time than expected.
Actions:
•
Remove the jammed sheet (if any) from underneath the vacuum belts. If the
sheet is damaged, discard it.
•
Check the paper path for any obstructions or debris.
•
Check that all sheets in the stack are the same length.
•
Check that the paper loaded in the feeder matches the parameters (size and
thickness) set in the UI.
•
Fan the paper stack to ensure sheets are not stuck together and there is no
excessive buildup of static electricity.
FE-106 - Out of paper
Table empty sensor Q11 checks if paper is present on the table during the feed cycle. If no
paper is detected, the machine stops the cycle and displays code FE-106. In most cases
this is part of normal operation and is not a cause for concern.
Actions:
•
Load more paper and continue the cycle.
•
If there is paper on the table, but the error persists, clean the table empty
sensor Q11. If the problem persists after that, contact service.
76
Continued on next page...
Advertisement
Table of Contents
