Table of Contents
Advertisement
FO-310 - Folder 2 position error
This error occurs when the Q42 Blade drive 2 home sensor is not actuated in time during
run.
Actions:
-Remove misfed sheet(s)
-Ensure that there are no obstructions in the paper path
FO-311 - Folder position error
3
This error occurs when the Q47 folder knife drive home sensor not actuated in time during
run.
Actions:
-Remove any misfed sheet(s)
-Ensure that there are no obstructions in the paper path
FO-312 - Exit sensor not covered in time
This error occurs when the Q52 sensor is not actuated in time during run.
Actions:
-Remove any misfed sheet(s)
-Ensure that there are no obstructions in paper path
FO-313 - Exit sensor not uncovered in time
This error occurs when the Q52 sensor is not uncovered in time during run.
Actions:
-Remove any misfed sheet(s)
-Ensure that there are no obstructions in paper path
FO-314 - Edge Sensor not covered in time
This error occurs when the Q45 sensor is not covered in time during run.
Actions:
-Remove any misfed sheet(s)
-Check that creaser tools are in open position (see setting crease pressure)
-Ensure that there are no obstructions in paper path
FO-315 - Edge Sensor not uncovered in time
This error occurs when the Q45 sensor is not uncovered in time during run.
Actions:
-Remove any misfed sheet(s)
-Check that papers in stacker do not block exiting papers
-Ensure that there are no obstructions in paper path
79
Advertisement
Table of Contents
