Setting Crease Tilt Knob - Formax Atlas C350 Operator's Manual

Setting Crease Tilt Knob

1. Run a proof sheet with a single crease and inspect the output.
1
2. If the crease is skewed, adjustment is necessary.
NOTE:
Wrong crease positions are marked in red, correct crease position is marked in green.
Feed direction
3. To adjust crease skew, loosen the crease adjustment knob by rotating it counterclock-
wise.
NOTE:
In the below image the optional additional static creaser is shown.
30
Crease
Continued on next page...