Table of Contents
Advertisement
Custom Job
To fully customize the number and position of creases on the sheet set up a custom job:
•
Use the Disable button to temporarily suspend
the selected crease without deleting it (for ex-
ample, when programming jobs in two passes)
•
The Invert button disables all currently ena-
bled creases and enables all currently disabled
creases. Use this when running jobs in two
passes.
1. Click the Pattern button on the
Home screen
NOTE:
Choosing a new pattern will reset
any fine adjustments that may have
been entered on other screens.
2. Select Custom job.
NOTE:
The custom job will be based on
the previously selected pre-set.
3. Custom job screen:
•
Click Add crease to add more
creases to the list.
•
Select a crease and use the + / -
buttons to adjust its position.
•
Use the Delete button to remove
the selected crease from the list.
•
The Swap creaser button can be
used to select whether the 1st or
the 2nd creaser will be used to
make this crease (only available if
the optional creaser unit has been
installed).
•
Use the Proof button to test run a
single sheet.
•
When satisfied, click the green
check mark.
2
63
Advertisement
Table of Contents
