Table of Contents
Advertisement
FE-108 - Paper table overload
In order to stop paper table movement in case it is overloaded paper stack height sensor
Q4 measures the amount of paper on the table when feed cycle starts. If the media used is
longer than 700 mm (27.6") the permitted paper stack height is limited to 100 mm (3.9"). If
this height is exceeded the machine displays error code FE-108.
Actions:
•
Check that the paper loaded in the feeder matches the parameters (size and
thickness) set in the UI.
•
Remove some of the paper stack from the feeder table.
•
If the is paper stack is below the lower stack height marker on the paper wall,
but the error persists, clean the paper stack height sensor Q4. If the problem
persists after that, contact service.
FE-109 - Too much paper
In order to stop paper table movement in case it is overloaded paper stack height sensor
Q4 measures the amount of paper on the table when feed cycle starts. If the media used is
shorter than 700 mm (27.6") the permitted paper stack height is limited to 200 mm (7.9"). If
this height is exceeded the machine displays error code FE-109.
Actions:
•
Remove some of the paper stack from the feeder table.
•
If the is paper stack is below the higher stack height marker on the paper wall,
but the error persists, clean the paper stack height sensor Q4. If the problem
persists after that, contact service.
FE-112 - Double Sheet Detector (DSD) blocked
When starting the feed cycle each sensor is automatically checked for obstructions. Error
code FE-112 is shown if the ultrasonic double sheet detector (US DSD) Q10 is blocked
during cycle start.
Actions:
•
Remove any jammed sheets from the paper path. If the sheet is damaged, dis-
card it.
•
Check the paper path for any obstructions or debris.
•
If there is nothing covering the sensor, but the problem persists, clean sensor
Q10 using the sensor cleaning brush. If the problem persists after that, contact
service.
Continued on next page...
3
77
Advertisement
Table of Contents
