Table of Contents
Advertisement
WARNING!
All blades are very sharp: use extreme caution. Leather gloves must be worn
whenever handling the blades.
4. Rotate the bottom assembly 180° from the top assembly as shown below.
1
5. Loosen grub screws [A] (x5). Shown on previous page.
6. Lift out the anvil strip [E].
7. Rotate anvil strip 180°. Or. Replace with spare.
E
8. Insert the anvil strip into the anvil channel.
9. Ensure the anvil strip is fully inserted and aligned with the edge of the anvil [B]. Shown
on previous page.
10. Tighten grub screws [A] (x5).
11. Rotate the bottom assembly 180° back into line with the top assembly.
12. Replace bolt [C] and spring [D] and tighten.
42
Advertisement
Table of Contents
