Table of Contents
Advertisement
5.
MAINTENANCE
Warning
•
Disconnect the mains power supply before performing any maintenance.
The user must not attempt to service the appliance beyond that described in
this operator manual. All other servicing must be carried out by qualified
service personnel only.
Please contact your authorized distributor.
5.1
Operator Maintenance
Maintenance
frequency
Daily
Weekly
When necessary
72
Maintenance
•
Check the system functions.
•
Keep the system in proper condition by removing dust, paper
remains, etc.
•
When dirty, clean the sealing table and rubber rollers with a
slightly wetted cloth, soaked in warm water.
•
When dirty or saturated, clean the brushes of the envelope
sealing.
The machine is delivered with an extra set of brushes. To always
have one clean set available, it is recommended to soak one set
in water and use the other set.
Remove the brushes one by one by pulling them down from the
brush holder.
Replace the brushes and make sure that the studs on the brushes
are fitted in the corresponding holes in the brush holder.
•
Check moistening cloth and replace if necessary.
When dirty or saturated, clean the moistening cloth and the
reservoir.
•
Clean feed and insert rollers as instructed by the service
engineer.
•
When the display warns about dusty sensors, the sensors on the
envelope or document path must be cleaned.
Note
When finished cleaning the sensors always calibrate the sensors
(see "Test" on page 20).
Advertisement
Table of Contents
