Operator Troubleshooting - Formax 6600 Series Operator's Manual

10.3

Operator troubleshooting

Symptom Possible cause
The machine cannot be Machine not connected
started after switching to mains.
on.
Fuse is blown.
A cover is opened.
Machine stops with Envelopes stacked
envelope at insert reversed in the hopper.
position (flap not open).
Envelope flap sticks.
Wrong envelope type
used (not according
specifications or job
settings).
Envelopes are double Envelope separation not
fed. correctly adjusted.
Envelopes not placed
properly in the hopper.
Envelope stop skewed. Side guides of the
envelope hopper are set
too wide.
Envelopes are fed Hopper almost empty.
irregularly.
Separation set too
narrow.
Side guides set too
narrow.
Envelope support not
positioned correctly.
Flap is wrinkled and Envelope not within
sometimes not opened. specifications.
Remedy Section
Connect the machine to -
the mains.
Replace fuse below -
power switch.
Close the covers -
Check envelope feed Adjustments for
adjustments. Place envelope feeding.
envelopes correctly in
hopper.
Store envelopes Specifications.
according to
specifications.
Change envelopes Specifications.
according to
specifications.
Check separation Adjustments for
settings, adjust if envelope feeding.
needed.
Check and replace if Adjustments for
needed. envelope feeding.
Check side guides and Adjustments for
adjust if needed. envelope feeding.
Refill hopper. Adjustments for
envelope feeding.
Check separation Adjustments for
settings, adjust if envelope feeding.
needed.
Check side guides and Adjustments for
adjust if needed. envelope feeding.
Reposition the envelope Adjustments for
support. envelope feeding.
Check specifications Specifications.
and change envelopes if
needed.
1-800-658-8788
www.abcoffice.com
43