Table of Contents
Advertisement
DAILY MAINTENANCE
1. It is recommended to let forms cool for one-half hour, from the laser printer, before folding and
sealing. This allows toner to set on the forms, and static electricity to discharge. The 400 Series Jogger
is recommended for best results. The Jogger squares the forms and dissipates heat and static created
by laser printers.
2. If toner builds up on the metal sealer rollers, clean the rollers with a lint-free cloth dampened
sparingly with a mild household cleaner.
3. Clean in-feed wheels and fold rollers with Formax-recommended roller cleaner & rejuvenator to
remove paper dust and toner. A damp cloth with water is the best alternative. CAUTION: Do not use
any chemicals other than the roller cleaner & rejuvenator or water.
TROUBLESHOOTING
Clearing paper jams:
WARNING: Turn machine off and unplug cord from its receptacle.
1. If a jam occurs in between the metal sealing rollers, remove any remaining forms from the
hopper. Remove the top cover and the upper fold plate. Remove the jam-clearing tool (located
under top fold plate), apply the tool to the upper metal roller (figure 7) and turn clockwise
(Caution: Do not apply excessive force or rollers may be damaged) until the paper jam is clear.
Remove the jammed form and return tool in holder and reinstall the upper fold plate. Reinstall
cover and press the start button.
Note: Press the black button (figure 8) near the power cord inlet to reset the breaker if necessary.
Figure 7
2. If a jam occurs in the fold plates, remove fold plate and remove paper. Reinstall fold plate.
Figure 8
6
Advertisement
Table of Contents
