General Configuration Screen - Cabletron Systems 6E122-26 User Manual

5.15

GENERAL CONFIGURATION SCREEN

The General Configuration screen,
system date and time, IP address and subnet mask, the default gateway,
the TFTP Gateway IP address, the Operational Mode, the Management
Mode, and the COM port configuration. The General Configuration
screen also allows the user to Clear NVRAM, and enable or disable IP
Fragmentation.
Access the General Configuration screen from the Module Configuration
Menu screen by using the arrow keys to highlight the GENERAL
CONFIGURATION menu item and pressing ENTER. The General
Configuration screen,
Event Message Line
Module Type: 6E122-26
Slot Number: X
MAC Address:
IP Address:
Subnet Mask:
Default Gateway:
TFTP Gateway IP Addr:
Operational Mode: [802.1D SWITCHING]
Com: [ENABLED]
Clear NVRAM [NO]
SAVE
The following briefly explains each General Configuration screen field:
MAC Address (Read-Only)
Displays the base physical address of the module.
IP Address (Modifiable)
This display allows the IP address to be set for the 6E12X-26 and
6E13X-25. To set the IP address, refer to
6E122-26, 6E132-25, 6E123-26 and 6E133-25 User's Guide
Figure 5-18, displays.
6E122-26 LOCAL MANAGEMENT
General Configuration
00-00-ID-00-00-00
0.0.0.0
255.255.0.0
NONE DEFINED
0.0.0.0
Application:
IP Fragmentation [ENABLED]
Figure 5-18 General Configuration Screen
General Configuration Screen
Figure 5-18, allows the user to set the
Firmware Revision:
BOOTPROM Revision: XX.XX.XX
Module Date:
Module Time:
Screen Refresh Time:
Screen Lockout Time:
Module Uptime XX D XX H XX M
Management Mode: [DISTRIBUTED]
[LM]
EXIT
Section
XX.XX.XX
10/11/97
14:23:00
30 sec.
15 min.
RETURN
5.15.1.
1960_15
5-41