High Speed Interface Configuration Menu Screen (6E12X-26 Only) - Cabletron Systems 6E122-26 User Manual

Chapter 5: Local Management
5.22 HIGH SPEED INTERFACE CONFIGURATION MENU
SCREEN (6E12X-26 ONLY)
When the HIGH SPEED CONFIGURATION MENU is selected
NOTE
for the 6E13X-25 the applicable HSIM Setup screen displays.
Refer to the HSIM User's Guide to set operating parameters for
the HSIM installed in the 6E13X-25.
Access the High Speed Interface Configuration Menu screen from the
Module Specific Configuration Menu screen by using the arrow keys to
highlight the HIGH SPEED INTERFACE CONFIGURATION
MENU menu item and pressing ENTER. The High Speed Interface
Configuration screen displays.
The High Speed Interface Configuration screen,
NOTE
applies only to ports 25 and 26 of the 6E12X-26. This screen
supports the FE-100TX, FE-100FX and FE-100F3 Fast
Ethernet Interface Modules that operate at 100 Mbps. If you are
configuring a 6E13X-25, refer to the applicable HSIM User's
Guide, or proceed to
The High Speed Interface Configuration screen displays the types of
interfaces installed in ports 25 and 26, their current operating mode, and
indicates if the ports are linked. This screen also allows the user to enable
or disable Auto-Negotiation and set the Advertised Ability.
5-74 6E122-26, 6E132-25, 6E123-26 and 6E133-25 User's Guide
Section 5.23.
Figure 5-28,