Flash Download Screen - Cabletron Systems 6E122-26 User Manual

3. Use the LEFT-ARROW key to move back to the Advertised Ability
selection and use the SPACE bar to select the next mode to enable or
disable.
4. Use the RIGHT-ARROW key to move across to the
Enabled/Disabled field to the right of the selection.
5. Use the SPACE bar to select Enabled or Disabled. Press ENTER.
Continue this process until you have completed enabling or disabling
the advertised modes.
6. Use the arrow keys to highlight the SAVE command. Press ENTER.
The message "SAVED OK" displays and Local Management saves
the changes to memory.
5.23

FLASH DOWNLOAD SCREEN

The Flash Download screen, shown in
clear the information stored in the 6E12X-26 and 6E13X-25 FLASH
memory and download a new image file from a TFTP server.
The user may also force a download by changing the position
NOTE
of Switch 6 located inside the module. Refer to
Setting the Mode
Before downloading a new image to the module, load the image onto the
network TFTP server.
For information on how to set up a workstation as a TFTP
NOTE
server, refer to the specific workstation documentation.
Access the Flash Download screen from the Module Specific
Configuration screen by using the arrow keys to highlight the FLASH
DOWNLOAD menu item and pressing ENTER. The Flash Download
screen displays.
6E122-26, 6E132-25, 6E123-26 and 6E133-25 User's Guide
Figure
Switch, for details.
Flash Download Screen
5-29, allows the user to
Section C.2,
5-79