Built-In Commands - Cabletron Systems 6E122-26 User Manual

The conventions used in describing the commands in Network
NOTE
Tools are as follows:
Arguments enclosed by [ ] are required.
Arguments enclosed by < > are optional.
In the following command examples, the information entered by
the user is shown in bold Helvetica font
To abort the output or interrupt a process, press the CONTROL
key and c key simultaneously, designated as ^C here.
The commands are presented in the following format:
command:
Syntax:
Description:
Options:
Example:

5.30.1 Built-in Commands

The built-in commands listed in this section activate functions on the
managed device or devices being accessed through Network Tools.
arp:
Syntax:
Description:
6E122-26, 6E132-25, 6E123-26 and 6E133-25 User's Guide
Shows the required command format. It
indicates where arguments, if any, must be
specified.
Briefly describes the command and its uses.
Lists any additional fields in the appropriate
format that may be added to the command.
Shows an example of the command.
arp <options>
The arp command provides access to the ARP
(Address Resolution Protocol) cache, enabling
you to view cache data, delete entries, or add a
static route. Super-User access is required to
delete an entry or add a static route.
Network Tools
.
5-105