Setting The Module Time - Cabletron Systems 6E122-26 User Manual

3. Press ENTER to set the system calendar to the date in the input field.
4. Use the arrow keys to highlight the SAVE command at the bottom of
the screen and press ENTER.
If the date entered is a valid format, the Event Message Line at the top of
the screen displays "SAVED OK". If the entry is not valid, Local
Management does not alter the current value, but it does refresh the
Module Date field with the previous value.

5.15.6 Setting the Module Time

To set the module clock, perform the following steps:
If the 6C105 chassis has been assigned a chassis time, it is not
NOTE
necessary to assign a module time to the 6E12X-26 and
6E13X-25. All installed modules recognize the chassis time of
the 6C105.
1. Use the arrow keys to highlight the Module Time field.
2. Enter the time in an 24-hour format, HH:MM:SS.
When entering the time in the system time field, separators
NOTE
between hours, minutes, and seconds do not need to be added
as long as each entry uses two numeric characters. For
example, to set the time to 6:45
Module Time field.
3. Press ENTER to set the system clock to the time in the input field.
4. Use the arrow keys to highlight the SAVE command at the bottom of
the screen and press ENTER.
If the time entered is a valid format, the Event Message Line at the top of
the screen displays "SAVED OK". If the entry is not valid, Local
Management does not alter the current value and refreshes the Module
Time field with the previous value.
6E122-26, 6E132-25, 6E123-26 and 6E133-25 User's Guide
General Configuration Screen
.
., type "064500" in the
A M
5-49