Table of Contents
Advertisement
Site #1 is using the full T1, so all the Timeslots must have an Interface
assignment. Site #2 and Site #3 use only a fraction of the T1, but the total
quantity of Timeslots must match those of Site #1. Unused Timeslots
receive an Interface number of 000.
The Interface numbers of Site #1, Site #2 and Site #3 do not
NOTE
have to match. Only the quantity and position of Timeslots
must match (the service provider assigns the Timeslots).
3.2
THE WAN INTERFACE CONFIGURATION SCREEN
The following sections describe the features of the WAN Interface
Configuration screen. Access the screen by using the arrow keys to
highlight the WAN INT CONFIG command field at the bottom of the
WAN Physical Configuration screen, then press ENTER. The WAN
Interface Configuration screen shown in
<host name> Local Management
Interface Number:
Max Xmit Unit:
ProtMgr Iface:
Active Protocol:
FR LMI:
DLCI Address: 0
DLCI DCP En:
DLCI DCP Stat:
Comp Ratio:
Circuit State: [Invalid]
PORTS:
[1-32 ]
SAVE
Figure 3-4 WAN Interface Configuration Screen
WPIM-T1/DDS User's Guide
The WAN Interface Configuration Screen
WAN INTERFACE CONFIGURATION
CKT# IF# LID STATE
000
001
0
002
[0]
003
FR
004
[ANSI_94]
005
006
007
008
009
010
011
012
013
014
015
016
RETURN
Figure 3-4
Flash Image Version: xx.xx.xx
CKT# IF# LID STATE
017
001 Enet
UP
018
002 Enet DOWN
019
020
021
022
023
024
025
026
027
028
029
030
031
032
displays.
2750_04
3-7
Advertisement
Table of Contents
