Using The Console; Port Numbering; Figure 2-10 Csm And Tsm Leds - Cabletron Systems SmartSwitch 6500 User Manual

Using the Console

Ejector
Reset Button
POWER
ACTIVE
STANDBY
FAIL
ENET RDY
(Ethernet interface ready)
TX DATA
RX DATA
Ejector

Figure 2-10 CSM and TSM LEDs

2.5 USING THE CONSOLE
Use the SmartSwitch 6500 console interface to configure and manage your switch. The following is a description of
the console interface and its operation.
2.5.1

Port Numbering

The following convention is used for numbering physical ports on the SmartSwitch 6500:
slot number I/O module letter
For example, port 3 of I/O module A on the TSM in slot 5 is represented by:
Virtual ports are designated by a period (
example, virtual port 2 on physical port
2-20 SmartSwitch 6500 User Guide
CSM
ATM
CPU FAIL / MODE
Console Terminal
(RJ-45)
COM
POWER
ACTIVE
STANDBY
FAIL
ENET RDY
Ethernet Port
(10Base-T)
ENET
TX DATA
RX DATA
port number
), and the virtual port number is appended to the physical port number. For
.
is represented as:
7B1
TSM
Ejector ATM
TSM FAIL / OK
TSM FAIL/OK
CPU FAIL/MODE
B
Ejector
5A3
7B1.2
Switch Installation and Setup
DATA
NO SYNC
I/O Module
I/O Module