Managing The Smartswitch 6500; Console Commands That Affect The Agent - Cabletron Systems SmartSwitch 6500 User Manual

Agent Support
-
p2mpLeaf
•
atmVplReceiveTrafficDescrIndex — Doesn't accept ABR traffic descriptor
•
atmVplTransmitTrafficDescrIndex — Doesn't accept ABR traffic descriptor
Not Supported
The following MIB objects are not supported. If used, these objects return either the value zero or the message, "Not
supported."
•
atmInterfaceDs3PlcpTable
•
atmInterfaceTCTable
•
atmSvcVpCrossConnectTable
•
atmSigSupportTable
•
atmSigDescrParamTable
•
atmIfAdminAddrTable
•
atmVclAddrBindTable
•
atmAddrVclTable
•
atmVclGenTable
•
atmfMyOsiNmNsapAddress
•
lecRouteDescrTable
•
leRDArpTable
B.2

MANAGING THE SMARTSWITCH 6500

Your SmartSwitch 6500 must be IP reachable by the NMS before it can be managed. The default connection between
the SmartSwitch 6500 and the NMS is the SmartSwitch 6500 Ethernet interface. Use the
command to find the IP address of the SmartSwitch 6500. An NMS can use this IP address to reach the SmartSwitch
6500 through Ethernet. An NMS can also manage the SmartSwitch 6500 through one of its ATM ports if the
SmartSwitch 6500 has a client connection into a VLAN or emulated LAN.
Note that the SmartSwitch 6500 itself, is not reachable through ATM until a client for the switch is created and
participates as a member of a VLAN or ELAN. Your NMS uses that switch client's address to access and manage the
switch.
To create a client for the switch, use the
LANs.
Use the command to tell the SmartSwitch 6500 which interface to use when communicating with your
set mynmaddr
NMS. For detailed information about these commands, see the SmartSwitch 6500 Reference Manual.
B.2.1

Console Commands that Affect the Agent

The following is a list of the console commands that affect the operation of the SmartSwitch 6500 SNMP agent. For
detailed descriptions of these commands, see the SmartSwitch 6500 Reference Manual.
•
Community: Sets the community strings for the SmartSwitch 6500
command for VLANs and
add ipatmclient
Managing the SmartSwitch 6500
show switchconfig
for emulated
add laneclient
SmartSwitch 6500 User Guide B-7