DETAILED SECTION DESCRIPTIONS
June 10th, 1997
PRINTING
Bias Control (Other)
At the start and the end of any print process (including the cleaning and initial
toner supply modes), -50 ± 50 V is applied to the toner application roller, and
+250 ± 15 V is applied to the development roller. This is to avoid any toner
transfer to the drum.
Toner
Development Roller
+ 2 5 0 V
Drum Surface Voltage
G N D
Toner Application Roller
- 50V
H523D534.wmf
Note that the voltage difference between the toner application and develop-
ment rollers is kept the same as in printing, at 300 V. This keeps the same
amount of toner on the development roller at all times during the print run.
2-22