Ricoh Aficio FX10 Service Manual page 167

REPLACEMENT AND ADJUSTMENT
SCANNER
6.2. SCANNER
6.2.1. Contact Image Sensor
[C]
Move the image sensor [A] to the middle of scanning path. Then disconnect har-
nesses [B] and [C].
D: Contact Image Sensor Assembly (2 connectors)
After replacing the image sensor, do the following.
1. Reset the sensor clock signal using service function 10-3.
(See section 4-1-17; the clock is reset automatically when this function is
used.)
2. Make some test copies using book scanner and ADF mode.
A blank copy might be made when using the ADF after replacing the im-
age sensor. Refer to section 7.1.1 for more details.
Note: 1. Scanner guide shaft replacement:
If you replace the scanner guide shaft, put Launa Oil 40 on all
surfaces of the shaft (P/N: 54429103 - Launa Oil 40).
2. Do not remove the connector [E]. This may change the position of
the sensor element.
[E]
6 - 6
June 10th, 1997
[D]
[A]
[B]
H523R509.wmf