Ricoh Aficio FX10 Service Manual page 119

SERVICE TABLES AND PROCEDURES
BIT SWITCHES
Communication Switch 14
No FUNCTION
Inch-to-mm conversion
during transmission
0
0: Disabled 1: Enabled
1-5 Not used
Available unit of resolution
in which fax messages are
received
Bit 7 Bit 6 Unit
6
0 0 mm
7 0 1 inch
1 0 mm and inch
(default)
1 1 Not used
Communication Switch 15 - Not used (do not change the settings)
Communication Switch 16 - Not used (do not change the settings)
Communication Switch 17 - Not used (do not change the settings)
Communication Switch 18 - Not used (do not change the settings)
Communication Switch 19 - Not used (do not change the settings)
Communication Switch 1A - Not used (do not change the settings)
Communication Switch 1B - Not used (do not change the settings)
Communication Switch 1C - Not used (do not change the settings)
Communication Switch 1D - Not used (do not change the settings)
Communication Switch 1E - Not used (do not change the settings)
Communication Switch 1F - Not used (do not change the settings)
COMMENTS
0: Transmitting is always done in inch format.
1: If the other end only has mm-based resolution for
printing, the machine converts the scanned data to
mm-format before transmission.
Do not change the factory settings.
For the best performance, do not change the factory
settings.
The setting determined by these bits is informed to the
transmitting terminal in the pre-message protocol
exchange (in the DIS/NSF frames).
4-34
June 10th, 1997