Table of Contents
Advertisement
REPLACEMENT AND ADJUSTMENT
IMAGE ADJUSTMENT
2. 2.ADF
Parameter
This parameter changes the start bit of the
main scan.
To increase the margin by X mm:
W1
New setting = Current setting + X/0.508
To decrease the margin by X mm:
New setting = Current setting + X/0.508
W2
Not adjustable
L1
This parameter changes the number of tx
motor steps after the scan line sensor is
activated.
To increase the margin by x mm:
New setting = Current setting + 7.875x
To decrease the margin by x mm:
New setting = Current setting - 7.875x
Initial setting of L1: 2 mm
L2
Not adjustable (Original length - L1 - L3)
This parameter changes the number of tx
motor steps after the scan line sensor is
deactivated.
To increase the margin by x mm:
L3
New setting = Current setting - 7.875x
To decrease the margin by x mm:
New setting = Current setting + 7.875x
Initial setting of L3: 2 mm
Formula
H523R562.WMF
6 - 38
June 10th, 1997
RAM
Unit
Address
8002A2(H) 0.508mm
800296(H)
1
mm
(low)
7.875
800297(H)
(high)
800298(H)
1
(low)
mm
7.875
800299(H)
(high)
Initial
Setting
02(H)
(02to04)
3F(H)
(0to200)
5C(H)
(0to200)
Advertisement
Chapters
Table of Contents
