Table of Contents
Advertisement
SERVICE TABLES AND PROCEDURES
BIT SWITCHES
System Switch 02
No
FUNCTION
Memory file transfer
0: Disabled
1: Enabled
0
1-2 Not used
Memory file printout
0: Disabled
3
1: Enabled
4-5 Not used
Memory read/write by RDS
Bit 7
6
Setting
0
0
Always disabled
0
1
User selectable
6
1
0
User selectable
1
1
Always enabled
7
System Switch 03
No
FUNCTION
Length of time that RDS is
0
temporarily switched on
to
when bits 6 and 7 of
System Switch 02 are set to
7
"User selectable"
System Switch 04
No
FUNCTION
LCD contrast
Bit
2
1
0
0
0
0
0
0
0
1
to
↓
2
1
1
0
1
1
1
Dedicated transmission
3
parameter programming
0: Disabled 1: Enabled
4
Not used
1: All messages in the memory (including confidential
rx messages) are sent to the fax number which is
programmed as the service station.
Always reset this bit to zero after transfer.
Cross reference
Service station number programming: Function 13
Do not change the setting.
1: All SAF files, including confidential messages, can
be printed using Function 54 or 55.
Always reset this bit after printing the messages.
Do not change the settings.
(0,0): All RDS systems are always locked out.
(0,1), (1,0): Normally, RDS systems are locked out, but
the user can temporarily switch RDS on to allow RDS
operations to take place. RDS will automatically be
locked out again after a certain time, which is stored in
System Switch 03 (see below). Note that if an RDS
operation takes place, RDS will not switch off until this
time limit has expired.
(1,1): At any time, an RDS system can access the
machine.
00 - 99 hours (BCD).
This data is only valid if bits 6 and 7 of System Switch
02 are set to "User selectable".
The default setting is 24 hours.
Use these bit switches to adjust the contrast of the
Contrast
LCD on the operation panel.
Brightest
↓
↓
↓
Darkest
This bit must be set to 1 before changing any
dedicated transmission parameters.
Do not change the settings.
4-20
June 10th, 1997
COMMENTS
COMMENTS
COMMENTS
Advertisement
Chapters
Table of Contents
