Ricoh Aficio FX10 Service Manual page 238

Hide thumbs Also See for Aficio FX10:
Table of Contents

Advertisement

June 10th, 1997
Code
Meaning
6-01
G3 ECM - no V.21 signal
was received
6-02
G3 ECM - EOR was
received
6-03
G3 ECM - non-standard
V.21 code received
6-04
G3 ECM - RTC not
detected
6-05
G3 ECM - facsimile data
frame not received within
18 s of CFR, but there
was no line fail
6-06
G3 ECM -
coding/decoding error
6-08
G3 ECM - PIP/PIN
received in reply to
PPS.NULL
6-09
G3 ECM - ERR received
6-10
G3 ECM - error frames
still received at the other
end after all
communication attempts
at 2400 bps
6-11
G3 ECM - printing
impossible because of a
missing first line in the
MMR coding
6-21
V.21 flag detected during
high speed modem
communication
6-39
V.21 signal not stopped
within 6 s
9-07
Paper non-feed or jam
at the cassette entrance
9-08
Paper jam inside the
development area
9-09
Paper jam in the fusing
exit area
9-10
Toner end detected
Suggested Cause/Action
Try adjusting the rx cable equalizer.
Replace the FCU or NCU.
The other terminal may be defective.
Check the line connection.
Check connections from the NCU to the FCU.
Check for a bad line or defective remote terminal.
Replace the FCU or NCU.
Check the line connection.
Check connections from the NCU to the FCU.
Check for a bad line or defective remote terminal.
Replace the FCU or NCU.
Try adjusting the rx cable equalizer
Cross reference
Rx cable equalizer - G3 Switch 07 (PSTN)
Defective FCU.
The other terminal may be defective.
The other end pressed Stop during communication.
The other terminal may be defective.
Check for a noisy line.
Adjust the tx levels of the communicating machines.
See code 6-05.
Check for line noise.
Adjust the tx level (use NCU parameter 01 or the
dedicated tx parameter for that address).
Check the line connection.
Defective remote terminal.
Check for problems in the printer mechanism.
The other terminal may be defective or incompatible.
Replace the FCU.
If the problem persists, replace the FCU.
Cross reference
Paper non-feed - Section 7-2-2
Jam at the cassette entrance - Section 7-2-2
If the problem persists, replace the FCU.
Cross reference
Paper jam - Section 7-2-2
If the problem persists, replace the FCU.
Cross reference
Paper jam - Section 7-2-2
Replace the CTM.
7-33
TROUBLESHOOTING
ERROR CODES

Advertisement

Table of Contents
loading

Table of Contents