Ricoh Aficio FX10 Service Manual page 175

REPLACEMENT AND ADJUSTMENT
DEVELOPMENT
Initial Toner Supply
After installing a new development unit, do the following:
1. Set bit 3 of RAM address 8003B0 to 1.
2. Turn off the machine and wait for 10 seconds.
3. Turn on the machine.
4. The machine will supply new toner to the development unit.
6.4.6. Toner Metering Blade
[D]
[C]
[B]
To install a new toner metering blade [A], do the following:
1. Set a new toner metering blade, as shown.
2. Set the Blade tools [C] (P/N: H5239520) on the development roller shaft
[B].
3. Set the pins [D] into the holes [E] on the metering blade frame.
4. Fasten with the screw each end of the metering blade while holding down
the tool [C].
5. Remove the tools [C].
[E]
6 - 14
September 1st, 1997
[A]
[D]
[C]
[B]
H523R565.wmf