Table of Contents
Advertisement
6
Notes about this Documentation
1
Notes about this Documentation
Always retain this documentation!
This documentation is part of the product. Therefore, retain the documentation
during the entire service life of the product. Pass on the documentation to any
subsequent user. In addition, ensure that any supplement to this documentation
is included, if necessary.
1.1
Validity of this Documentation
This documentation is only applicable to the I/O module 750-496
(8AI 0/4-20mA S.E.).
The I/O module 750-496 shall only be installed and operated according to the
instructions in this manual and in the manual for the used fieldbus coupler or
controller.
Consider power layout of the WAGO-I/O-SYSTEM 750!
In addition to these operating instructions, you will also need the manual for the
used fieldbus coupler or controller, which can be downloaded at www.wago.com.
There, you can obtain important information including information on electrical
isolation, system power and supply specifications.
1.2
Revision History
Table 1: Revision History
Document
Version
1.0.1
1.1.0
1.2.0
1.2.2
1.3
Copyright
This Manual, including all figures and illustrations, is copyright-protected. Any
further use of this Manual by third parties that violate pertinent copyright
provisions is prohibited. Reproduction, translation, electronic and phototechnical
filing/archiving (e.g., photocopying) as well as any amendments require the
written consent of WAGO Kontakttechnik GmbH & Co. KG, Minden, Germany.
Non-observance will involve the right to assert damage claims.
Manual
Version 1.2.2
Device Version
Hardware
Software
‒
‒
01
01
01
01
01
01
WAGO-I/O-SYSTEM 750
750-496 8AI 0/4-20mA S.E.
Description of Change
First issue
Total revision with new layout
Change of approvals
Editorial revision
Advertisement
Chapters
Table of Contents
