Table of Contents
Advertisement
32
Process Image
4.2
Status Bytes
Status bytes are identically implemented for all channels. Therefore, the following
description in this section applies to all status bytes of the I/O module.
Table 18: Status Byte CH1_S0
Bit 7
RegCom
Underrange
Overrange
User
Underrange
User Overrange
Short Circuit
Wire Break
General Error
RegCom
1)
Does not apply to 0 ... 20 mA (ID0)
Manual
Version 1.2.2
Status byte CH1_S0, Byte 1
Bit 6
Bit 5
Bit 4
General
Wire
Short
Error
Break
Circuit
Underrange
0:
The field-side input current is above the current lower limit.
1:
The field-side input current is below the current lower limit.
Range exceeded
0:
The field-side input current is below the current upper limit.
1:
The field-side input current is above the current upper limit.
User limiting value underrange
0:
The field-side input current is above the current lower limit configured by
the user.
1:
The field-side input current is below the current lower limit configured by the
user.
User limiting value overrange
0:
The field-side input current is below the current upper limit configured by
the user.
1:
The field-side input current is above the current upper limit configured by
the user.
Short circuit
0:
The field-side input current is within the maximum permissible input current
range.
1:
The field-side input current is above the maximum permissible input current
range.
1)
Wire break
0:
The field-side input current is above 1 mA.
1:
The field-side input current is below 1 mA.
General error
0:
No error or bit 0 (underrange), bit 1 (overrange), bit 4 (short circuit) or bit 5
(wire break) is/are not set.
1:
General error; bit 0 (underrange) or bit 1 (overrange) is/are set.
Register communication
0:
Register communication is disabled (normal mode).
1:
Register communication is enabled.
WAGO-I/O-SYSTEM 750
750-496 8AI 0/4-20mA S.E.
Bit 3
Bit 2
User
User
Over-
Underrange
range
Bit 1
Bit 0
Over-
Underrange
range
Advertisement
Chapters
Table of Contents
