Hisun HS700UTV-4 Maintenance Handbook page 349

TROUBLESHOOTING
IF THE FOUR-WHEEL DRIVE INDICATOR FAILS TO COME ON:
Procedure
Check:
1. Fuses (main, four-wheel drive)
2. Battery
3. Main switch
4. Four-wheel drive relay 1
5. Four-wheel drive relay 2
6. Four-wheel drive relay 3
1. Fuses (main, four-wheel drive)
Refer to "CHECKING THE SWITCH".
2. Battery
• Check the battery condition. Refer to
"CHECKING AND CHARGING THE BATTERY"
in chapter 3.
Open-circuit voltage:
12.8 V or more at 20 °C (68 °F)
3. Main switch
Refer to "CHECKING THE SWITCH".
ELECTRICAL COMPONENTS
CONTINUITY
CORRECT
CORRECT
7. On-Command four-wheel drive switch and
differential gear lock switch
8. Gear motor
9. Wiring connections
(the entire 2WD/4WD selecting system)
1NOTE:
• Remove the
troubleshooting.
1. Console
• Use the following
troubleshooting.
NO CONTINUITY
Replace the fuse
INCORRECT
• Clean the battery terminals.
•Recharge or replace the battery
INCORRECT
Replace the main switch.
- 336 -
following part(s)
special tool(s)
before
for