Table of Contents
Advertisement
ENGINE
• starter idle gear teeth ①
• starter wheel gear teeth ②
Burrs/clips/roughness/wear
• starter wheel gear
(contacting surface)
Damage/pitting/wear
3). Checking the engine cooling fan
• engine cooling fan
• air shroud 1
• air shroud 2
Cracks/damage
2、INSTALL
• woodruff key
• A.C. magneto rotor
1NOTE:
• Before installing the rotor, clean the
outside
of the crankshaft and the inside of the rotor.
• After installing the rotor, check that the
rotor rotates smoothly. If not, reinstall the
key and rotor.
• dowel pins
• gasket (New replacement)
• A.C. magneto cover(10Nm)
1NOTE:
• When installing the A.C. magneto cover,
use a long rod to hold the A.C. magneto
rotor in position from the outside. This will
make assembly easier. Be careful not to
damage the oil seal.
• Apply sealant (Quick Gasket) ① to the
thread of the bolt ② shown in the
illustration.
• Tighten the bolts in stages, using a
crisscross pattern.
- 158 -
Replace.
Replace.
Replace.
Advertisement
Table of Contents
Troubleshooting
