Hisun HS700UTV-4 Maintenance Handbook page 138

MAINTENANCE AND ADJUSTMENT OF THE UTV
YES
Adjust the voltage to obtain the
standard charging amperage
Set the timer to the charging time
determined by the open circuit
voltage.
If the required charging time exceeds 5 hours, it is advisable to check the charging
amperage after 5 hours. If there is any change in the amperage, readjust the voltage to
obtain the standard charging amperage.
Leave the battery unused for more than 30 minutes before measuring its open-circuit
voltage.
12.8 V Charging is complete.
12.0 ~ 12.7 V
Measure the open-circuit voltage
prior to charging.
Connect a charger and ammeter to
the battery and start charging.
Is the amperage higher than the
standard
written on the battery?
YES
Recharging is required.
charging amperage
- 125-
NO
Adjust the charging voltage to
20 ~ 25 V
Monitor the amperage for 3 ~ 5
minutes. Is the standard charging
amperage exceeded?
NO
If the amperage does
exceed the standard charging
amperage after 5
replace the battery.
not
minutes,