Changing The Coolant - Hisun HS700UTV-4 Maintenance Handbook

MAINTENANCE AND ADJUSTMENT OF THE UTV

CHANGING THE COOLANT

1. Remove:
·driver seat
·passenger seat
·console
Lift the hood up.。
·coolant reservoir cap ①
·Disconnect coolant reservoir hose ②
·Adding water instead of coolant lowers the
antifreeze content of the coolant. If water is
used instead of coolant, check and if
necessary,
concentration of the coolant；
·Use only distilled water. However, soft water
may be used if distilled water is not available.
2. Drain:
·coolant
(from the coolant reservoir)
3. Connect:
·coolant reservoir hose
4. Remove:
·coolant drain bolt (water pump)
the copper washer)
5. Remove:
·radiator cap ①
WARNING :
A hot radiator is under pressure. Therefore,
do not remove the radiator cap when the
engine is hot. Scalding hot fluid and steam
may be blown out, which could cause serious
injury. When the engine has cooled, open the
radiator cap as follows:
Place a thick rag or a towel over the radiator
cap and slowly turn the radiator cap
counterclockwise toward the detent to allow
any residual pressure to escape.
When the hissing sound has stopped, turn
the radiator cap counterclockwise while
- 98-
correct the antifreeze
(along with
①