Checking The Coolant Level - Hisun HS700UTV-4 Maintenance Handbook

MAINTENANCE AND ADJUSTMENT OF THE UTV
clean parts only. Never use gasoline or low
flash point solvents as they may cause a fire
or explosion.
b. Squeeze the excess solvent out of the
element and let it dry.
NOTE:
Do not twist or wring out the element. This
could damage the foam material.
c. Squeeze out the excess oil.
NOTE:
The element should be wet but not dripping.
4. Install:
·air filter element
·air filter case cover
NOTE:
To prevent air leaks make sure that the
sealing surface of the element matches the
sealing surface of the case.
console
·passenger seat
·driver seat

CHECKING THE COOLANT LEVEL

1. Place the vehicle on a level surface.
2. Lift the hood up.
3. Check:
· start the engine, warm it up for several minutes,
and then turn it off.
·coolant level
NOTE:
Before checking the coolant level, wait a few
minutes until the coolant has settled.
·coolant level
The coolant level should be between the
minimum level mark ○
mark ○ .Below the minimum level mark
b
Add the recommended coolant to the proper
level.
- 97-
and maximum level
a