Hisun HS700UTV-4 Maintenance Handbook page 246

CHASSIS
c. Install the parking brake arm to the parking
brake arm shaft so that the punch mark ⓒ on
the parking brake arm is aligned with the
punch mark ⓐon the parking brake arm shaft.
d. Turn the parking brake arm until it contacts the
pin ⓓ.
e. Finger tighten the set bolt.
f. Tighten the parking brake arm nut.
5. Install:
• brake pad (piston side) ①
(with insulator and pad shim)
1NOTE:
Align the projection a on the piston side of
the brake pad with the groove in the brake
caliper piston.
6. Install:
• brake pad holding bolts
17Nm (1.7 m · kg,12 ft · lb)
INSTALLING THE REAR BRAKE CALIPER
1. Install:
• brake caliper assembly
• brake caliper mounting bolts
40Nm (4.0m · kg,29 ft · lb)
• brake hose ①
• copper washers
• union bolt ②
48Nm (4.8m · kg,35 ft · lb)
1NOTE:
Tighten the union bolt while holding the
brake hose as shown.
1WARNING ：
Proper brake hose routing is essential to
insure safe vehicle operation.
2. Fill:
• brake reservoir
- 233-