Cleaning The Spark Arrester - Hisun HS700UTV-4 Maintenance Handbook

MAINTENANCE AND ADJUSTMENT OF THE UTV
·Replace V-belt:
Install the bolts ① into the secondary fixed
sheave hold.
NOTE:
Tightening the
secondary sliding sheave away, causing the
gap between the secondary fixed and sliding
sheaves to widen.
·Remove the V-belt ①from the primary sheave
and secondary sheave.
·Install the V-belt.
NOTE:
Install the V-belt so that its arrow faces the
direction shown in the illustration.
· Remove the bolts.
2. Install:
· drive belt cover
· console
· passenger seat
· driver seat

CLEANING THE SPARK ARRESTER

1. Clean:
Tap the tailpipe lightly with a soft-face hammer or
suitable tool, then use a wire brush to remove
any carbon deposits from the spark arrester
portion of the tailpipe and the inner contact
surfaces of the muffler..
2. spark arrester
WARNING:
· Select a well-ventilated area free of
combustible materials.
· Always let the exhaust system cool before
performing this operation.
· Do not start the engine when removing the
tailpipe from the muffler.
- 103-
bolts ① will push the