4. Starter relay
• Remove the starter relay from the wire
harness.
• Connect the pocket tester (Ω × 1) and the
battery (12 V) to the starter relay terminals.
Battery (+) terminal
①
Battery (–) terminal
②
Tester (+) lead
Red terminal ③
Tester (–) lead
Black terminal ④
• Check the starter relay for continuity.
5. Main switch Refer to "CHECKING THE
SWITCH".
6. Gear position switch Refer to "CHECKING
THE SWITCH".
7. Brake light switch Refer to "CHECKING THE
SWITCH".
8. Diode 1
• Remove the diode from the coupler
• Connect the pocket tester (Ω × 1) to the diode
terminals as shown.
• Check the diode for continuity as follows
ELECTRICAL COMPONENTS
TURNS
Yellow/Blue terminal
Blue/Black terminal
CONTINUITY
CORRECT
CORRECT
CORRECT
DOSE NOT TURN
Repair or replace the starter motor. Small
testers and battery and (12V) and start relay
terminal connection
Check continuity of the start relay
NO CONTINUITY
Replace the starter relay.
INCORRECT
Replace the main switch.
INCORRECT
Replace the gear position switch.
INCORRECT
Removed from the coupling diodes
Small diode Tester connection terminals, As
shown in the figure
Replace the brake light switch.
Check the diode continuity
- 312 -