Coolant Level - Hisun HS 250UTV Owner's/Operator's Manual

Hide thumbs Also See for HS 250UTV:
Table of Contents

Advertisement

Introduction HS 200UTV/HS 250UTV
2.
Observe
the
perspective window, if the oil level is below
the centerline perspective window must
add new oil..
[1] Oil cap
[2] Perspective window
■Checking Coolant Level
CAUTION
TO avoid personal injury
Do not remove radiator cap while
coolant is hot. When cool, slowly rotate
to the first stop and allow sufficient time
for excess pressure to escape before
removing the cap completely.
 Park the vehicle on a flat surface,
access the panel under the hood,
set the parking brake, and shut off
the engine.
 Check to see that the coolant level
is between the "FULL" and" LOW"
marks of recovery tank.
oil
level
through
 When the coolant level drops
the
due to evaporation, add coolant
only up to the full level. In case
of leakage add anti-freeze and
water in the specified mixing
ratio up to the full level.(see flush
cooling system and changing
coolant in EVERY 2 YEARS in
PERIODIC SERVICE section)
[1] Recovery tank
[2] FULL
[3] LOW
IMPORTANT
If the radiator cap has to be removed,
follow the cautions above and securely
retighten the cap.
Use clean fresh water and anti-freeze to
fill the recovery tank.
If water should leak, consult your local
HISUN Dealer.
1-37

Advertisement

Table of Contents
loading

This manual is also suitable for:

Hs 200utv

Table of Contents