Initial System Setup And Configuration; Setting Up Your System; Idrac Configuration; Options To Set Up Idrac Ip Address - Dell EMC PowerEdge T340 DPJ1G Installation And Service Manual

Setting up your system

Perform the following steps to set up your system:
1 Unpack the system.
2 Connect the peripherals to the system.
3 Connect the system to its electrical outlet.
4 Power on the system by pressing the power button or by using iDRAC.
5 Power on the attached peripherals.
For more information about setting up your system, see the Getting Started Guide that shipped with your system.

iDRAC configuration

The Integrated Dell Remote Access Controller (iDRAC) is designed to make system administrators more productive and improve the overall
availability of Dell systems. iDRAC alerts administrators about system issues and enables them to perform remote system management.
This reduces the need for physical access to the system.

Options to set up iDRAC IP address

To enable communication between your system and iDRAC, you must first configure the network settings based on your network
infrastructure.
NOTE: For static IP configuration, you must request for it at the time of purchase.
This option is set to DHCP by Default. You can set up the IP address by using one of the following interfaces:
Interfaces Document/Section
iDRAC Settings Dell Integrated Dell Remote Access Controller User's Guide at
utility
Dell Deployment Dell Deployment Toolkit User's Guide at
Toolkit
Dell Lifecycle Dell Lifecycle Controller User's Guide at
Controller
NOTE: To access iDRAC, ensure that you connect the ethernet cable to the iDRAC9 dedicated network port. You can also access
iDRAC through the shared LOM mode, if you have opted for a system that has the shared LOM mode enabled.

Log in to iDRAC

You can log in to iDRAC as:
• iDRAC user
18

Initial system setup and configuration

Initial system setup and configuration
Dell.com/openmanagemanuals
Dell.com/poweredgemanuals
Dell.com/poweredgemanuals
> OpenManage Deployment Toolkit
3