Next steps
1
Install the front
bezel.
2
Follow the procedure listed in
Removing the drive from the drive carrier
Prerequisites
1
Follow the safety guidelines listed in
CAUTION:
Mixing drive carriers from previous generations of PowerEdge servers is not supported.
2
Follow the procedure listed in
3
Remove the front bezel.
4
Remove the drive carrier.
Steps
1
Using a Phillips #1 screwdriver, remove the screws from the slide rails on the drive carrier.
2
Lift the drive out of the drive carrier.
Figure 32. Removing the drive from the drive carrier
Next step
1
Replace the drive into the drive carrier.
Installing the drive into the drive carrier
Prerequisites
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
3
Remove the front bezel.
4
Remove the drive carrier.
After working inside your
system.
Safety
instructions.
Before working inside your
Safety
instructions.
Before working inside your
system.
system.
Installing and removing system components
59