Table of Contents
Advertisement
Figure 4-55: Triple Lip Seal
11. Install a new cotter pin and replace the hub cap.
Figure
4-55)
ITEM
1
Hitch Clevis
2
Wheel Bearings-Pull Hitch
3
Ratchet Jack
t
3
1
HUB CAP
COTTER PIN
SEAL SHOULD POINT
AWAY FROM HUB
LUBRICATION TABLE
DESCRIPTION
RATCHET JACK
ASSEMBLY
Figure 4-56: Lubrication Points
OPERATION AND MAINTENANCE
Lubrication Maintenance
1.
See Figure 4-56
intervals on the Grain Drill. Proper maintenance of
your machine will, under normal operating
conditions, help to keep it operating at or near its
peak performance for an extended period of time.
Proper maintenance is also a condition of keeping
your warranty in good status
Lubrication" on page
2. The drill should be lubricated after initial setup and
prior to field operations. When lubricating the Grain
Drill, SAE multi-purpose EP grease, or EP grease
with 3-5% molybdenum sulfide is recommended.
Wipe soil from fittings before greasing. Replace any
lost or broken fittings immediately.
(See
NO. OF LUBE POINTS
2
1 zerk per/hub - 4 Total
1 zerk per/jack
specifies the lubrication points and
"Maintenance &
4-46.
INTERVAL
(Hours Unless Stated)
50
50
50
2
4-47
Advertisement
Table of Contents
