Lubrication Maintenance - Landoll 5211 Operator's Manual

Lubrication Maintenance

1. Table 5-1 specifies the lubrication points and intervals
on the 5211 Grain Drill. Proper maintenance of your
machine will, under normal operating conditions, help
to keep it operating at or near its peak performance
for an extended period of time. Proper maintenance is
also a condition of keeping your warranty in good
status See Figure 5-7.
ITEM DESCRIPTION
1 Coulter Hitch Lift-Lower Rockshaft
bearing cap
2 Coulter Hitch Lift-Upper Rockshaft
bearing cap
3 Coulter Hubs
4 Marker Arm
5 Marker Hub
5-4
TABLE OF CONTENTS
2. The drill should be lubricated after initial setup and
prior to field operations. When lubricating the Grain
Drill, SAE multi-purpose EP grease, or EP grease
with 3-5% molybdenum sulfide is recommended.
Wipe soil from fittings before greasing. Replace any
lost or broken fittings immediately.
3. The Grain Drill is equipped with maintenance-free
bearings in the lifts. These areas require no
lubrication.
LUBRICATION TABLE
NO. OF LUBE POINTS
2
2
1 each
4
2
Table 5-1: Lubrication Table
INTERVAL
(Hours Unless Stated)
50
50
50
50
50
F-725-0122