Table of Contents
Advertisement
7.3.3 View and edit all layouts
To show all existing layouts, select „All layouts" in the menu. A list of all saved
layouts will be displayed. The active layout will be shown as "selected".
To change the name or settings of a layout, tap the relevant entry in the list. The
values can then be changed in the same way as described in chapter 7.3.2 "Editing
the selected layout" on page 32.
7.4 Motor settings
Various settings for the motor can be changed via „Settings" -> „Motor settings" in
the menu.
7.4.1 Manual speed
Manual speed sets the speed at which the tool holder (4) moves when using the
„manual back"
7.4.2 Speed mode
There are two speed modes:
Normal 0 – 300 mm/s:
Schnell 0 – 600 mm/s:
If not specifically required otherwise, it is recommended to use the „Normal" speed
mode for the procedures.
7.4.3 Acceleration mode
There are three different acceleration modes:
Normal:
The normal mode is appropriate for most uses.
Increased:
The increased acceleration is for uses where the top speed of the
tool holder (4) needs to be reached quickly.
High:
The high acceleration mode is only appropriate for uses with very
high speed, requiring the top speed of the tool holder (4) to be
reached as fast as possible.
High acceleration mode can lead to a jerk at the start of the
drawing process.
If not specifically required otherwise, it is recommended to use the „Normal"
acceleration mode for most procedures.
or "manual forward"
The normal speed mode is appropriate for most uses.
The fast mode is for procedures requiring high
drawing speed.
buttons.
Page 33
Advertisement
Table of Contents
