The Motor Is Overheated - Proceq ZAA 2600.SW Instruction Manual

Automatic scrub tester
Table of Contents

Advertisement

7.6.4 The motor is overheated

The fields for cycle speed and stroke
length are marked red. After tapping on
the information symbol
will appear that either the cycle counts
or the cycle speed are too high.
Solution: The motor cannot reach the
preset number of double strokes with
the preset stroke length and speed.
Either the double stroke (cycle) speed
or the stroke length has to be reduced.
Alternatively, the acceleration mode or
speed mode of the motor can be
adjusted. For this see chapter 7.4
"Motor settings" on page 33.
If the motor of the unit is overheated,
this message appears and the current
action will be interrupted. Confirm the
message with OK, the device switches
off. Let the device cool down before
switching it on again. Arrange for
sufficient ventilation around the device.
The unit must not be operated outside
of the allowed temperature range.
Page 35
a message

Advertisement

Table of Contents
loading

Table of Contents