Startup - Proceq ZAA 2600.SW Instruction Manual

Automatic scrub tester
Table of Contents

Advertisement

Fix the drain hose (16) to the drain lead-out.
The drain hose (16) has to lead the liquid outwards. The hose must not point
into the unit. When using the device with liquids the drain hose (16) must be
mounted.
Place the sample frames (6) in the unit and while pressing them down fix the
screws with a quarter-turn.
Fold down the tool holder (4).
Move the start stop (1) backwards and the end stop (2) forward as far as
possible. Fasten their screws.
To protect persons and apparatus, proper care must be taken when lifting or
carrying it. It is recommended to hold and carry the Proceq ZAA 2600 on both
sides of the housing. Always remove the sample tray before lifting or tilting the
device.

5.2 Startup

Connect the device to a power socket with the supplied power cable and turn on the
main switch (15).
Switch on the device by pressing the power button (10). The device will be ready
after a short start-up phase.
(6)
(4)
(2)
Page 17
(1)

Advertisement

Table of Contents
loading

Table of Contents