Table of Contents
Advertisement
No oil shall be sprayed into the apparatus. The function of electrical or
mechanical components could be impaired.
For lubricating proceed as follows:
•
Remove the sample frames (6) and the sample tray (3) (see chapter 5.1
"Assembly" as from page 16).
•
Loosen the screws of the side panels (18) and remove both side panels (17)
with the Allen key.
•
Turn the apparatus carefully on one side so that the side opening of the cover
becomes accessible.
•
Put some drops of sewing machine oil on your finger and spread it over the
whole length of the guide rods.
•
Repeat this for the other side of the apparatus.
•
Adjust the start stop (1) at the very beginning and the end stop (2) at the very
end and move the tool holder (4) back and forth several times, so that the oil
gets evenly distributed over the whole length of the rods.
•
Remount the side panels (17), the one with slit on the right side, the other
one on the left side.
•
Remount the sample tray (3) and sample frames (6).
Page 49
Advertisement
Table of Contents
