Table of Contents
Advertisement
•
Loosen the screws of the height adjustment for tool holder (5). Place the tool
holder (4) in the highest position and fasten the screws.
•
Remove the four clips (8).
•
Mount the friction finger set in the lane above the sample and fasten it with the
screw. Alternatively, the modification set „Crockmeter" can be used.
Maximum load: 4,5 kg (99.21 lbs) (2 x 22 N).
•
Move the start stop (1) backwards and the end stop (2) forward as far as
possible. Fasten their screws.
•
Move the tool holder (4) either with
sample.
•
Press the „Zero" button
Do not zero directly at the start stop (1), but at least ca. 3 mm in front.
(5)
or manually to the back position of the
on the touchscreen to set the start position. Note:
Page 42
Advertisement
Table of Contents
