Zero The Scrub Tester; Scrubbing; Pause; Select Layout - Proceq ZAA 2600.SW Instruction Manual

move slowly. If the button is held for more than a second, the speed will increase.
Alternatively the tool holder (4) can also be moved by pushing it forward or
backwards in the middle of the holder.

7.1.2 Zero the scrub tester

7.1.3 Scrubbing

The scrubbing procedure starts when pressing the „Scrubbing" button
meter counts the double strokes made. The scrubbing procedure stops
automatically when the set number of double strokes has been reached.
One double stroke equates to one forward and backward movement of the tool
holder (4).

7.1.4 Pause

The scrubbing procedure can be interrupted by pressing the „Pause"
The procedure continues when tapping the „Scrubbing"

7.1.5 Select layout

The layout indicator shows the name of the currently selected layout. A layout is a
renameable memory slot storing speed and stroke length. This is especially useful
for recurring tasks where the same speed and length are required again.
The current layout can be selected by tapping the layout field.
The current position of the tool holder (4) can be
set to 0 by pressing the „Zero" symbol
Confirm the appearing message with „yes.
Should this button be pressed accidentally
during the procedure, you can abort the zeroing
process by pressing "no".
Note: Do not zero directly at the start stop (1),
but at least ca. 3 mm in front.
Page 28
. The
button.
button again.