Table of Contents
Advertisement
•
Move the tool holder (4) either with
sample.
•
Press the „Zero" button
Note: Do not zero directly at the start stop (1), but at least ca. 3 mm in front.
•
Moisten the chosen friction set according to standard and place it in the tool
holder (4).
Maximum load: 4.5 kg (99.21 lbs) (2 x 22 N).
•
Check the height of the sample frames (6) and adjust it with the screw (5) if
necessary.
(5)
•
Set the number of double strokes and stroke length on the touchscreen (refer
to chapter 7.1.7 "Setting the stroke length" on page 29).
or manually to the back part of the
on the touchscreen to set the start position.
(4)
(8)
(8)
Page 26
Advertisement
Table of Contents
